Oct 22, 2026 | Roofing

By Polat Ayhan, Founder of Maple Roofing and Masonry

During a roof inspection, a roofer checks the roof surface, the flashing around chimneys and vents, the eavestroughs and the attic below. They look for damage, leaks and wear, then explain what needs repair now, what can wait and whether the roof is near the end of its life. Use the roof inspection checklist below to see what each step covers.

  • A full roof inspection covers four areas: the roof surface, flashing and roof penetrations, eavestroughs and drainage, and the attic.
  • A general home inspection is a visual check that does not require walking the roof or predicting how long it will last (InterNACHI).
  • Most leaks start at flashing, vents and valleys, not in the middle of the shingles.
  • Book an inspection after a major storm, before buying or selling a home, and when your roof is near the end of its expected life.
  • Water stains inside are often several feet from where the water enters the roof.

What happens during a roof inspection?

A roof inspection is a close look at your roof, from the outside and the inside, to find damage before it turns into a leak. Most inspections follow the same four steps.

  1. A walk around the house. The roofer looks at the roof from the ground, checks the eavestroughs and downspouts, and notes any sagging lines or missing shingles.
  2. The roof surface. Where it is safe, the roofer goes up to check shingles or membrane, flashing, vents and the chimney. A steep, icy or fragile roof may be checked from a ladder at the eaves instead.
  3. The attic. From inside, the roofer looks for water stains, damp insulation, daylight through the deck and signs of poor ventilation.
  4. The findings. The roofer explains what they found, what needs attention now and what can wait.

What is on a roof inspection checklist?

A roof inspection checklist covers every part of the roof where water can get in or where wear shows first. The table below shows what a roofer looks at in each area.

Area What the roofer checks Common problems found
Shingles or membrane Missing, lifted, cracked or curled shingles; bald spots where granules have worn off; blisters, splits or open seams on flat roofs Wind damage, ageing shingles, flat roof seams pulling apart
Flashing Metal around chimneys, vents, skylights, valleys and walls Lifted, rusted or loose flashing; cracked sealant
Roof penetrations Plumbing vents, exhaust vents and skylights Cracked rubber boots around pipes, gaps around skylights
Chimney Bricks, mortar joints, chimney cap and flashing Crumbling mortar, loose bricks, leaks where the chimney meets the roof
Eavestroughs and downspouts Debris, sagging runs, loose joints, downspout outlets Overflow at the roof edge, water draining at the foundation
Fascia and soffit Boards along the roof edge and under the overhang Rot, staining, gaps where pests can get in
Roof deck and structure The roofline from the ground; soft spots underfoot Sagging sections, a soft deck from long-term leaks
Attic Underside of the deck, insulation, vents Water stains, mould, frost, blocked vents

In the GTA, a roof inspection checklist also includes winter damage. Ice dams, freeze-thaw cracking and snow load all show up as lifted shingles at the eaves, stains near outside walls and damaged eavestroughs. Our roof maintenance guide covers the seasonal checks you can do between inspections.

If your eavestroughs are sagging or overflowing, our eavestrough contractors can repair or replace them. Crumbling mortar or loose brick on the chimney is a job for our chimney repairs team.

What does a roofer check in the attic?

The attic shows problems the roof surface hides. A roofer looks at the underside of the roof deck for water stains, dark spots and mould, and checks the insulation for damp or flattened patches.

They also check ventilation. Blocked soffit vents or too little insulation let warm air reach the roof, and that warm air melts snow and causes ice dams. In winter, frost on the underside of the deck or on nail tips is a sign that moist air is collecting in the attic.

How is a roofer’s inspection different from a home inspection?

A home inspection looks at the roof as one part of the whole house, while a roof inspection by roofing contractors looks at the roof in detail. Under the InterNACHI Standards of Practice, a home inspector checks the roof from the ground or the eaves and is not required to walk on it.

Home inspection Roof inspection by a roofer
Where the roof is viewed from The ground, the eaves or accessible openings On the roof where safe, plus the attic
Walking the roof Not required Usually, where it is safe to do so
Remaining roof life Not required to predict Gives a view on repair or replacement
Who it suits Home buyers checking the whole house Owners with a leak, storm damage or an ageing roof

If a home inspection report flags the roof, a roofer’s inspection is the next step. It tells you what the problem is and what fixing it involves.

When should you book a roof inspection?

Book a roof inspection when something has changed, not only when you see a leak.

  • After a major storm. Wind, hail and fallen branches can lift shingles and damage flashing without any sign from the ground.
  • Before buying or selling a home. A roof inspection gives both sides a clear picture of the roof’s condition.
  • When the roof is ageing. Architectural asphalt shingles last about 30 years and 3-tab shingles about 20 years (InterNACHI). See the different types of roofing materials for other lifespans.
  • When you see signs inside. Stains on ceilings, damp insulation or peeling paint near the top of walls all point to water getting in.
  • Before winter. A fall inspection finds loose shingles and blocked eavestroughs before snow and ice make them worse.

What happens after the inspection?

After the inspection, the roofer explains what they found and recommends one of three next steps: no work for now, a repair, or a replacement.

Finding Usual next step
Roof in good condition Keep up seasonal maintenance and check again after major storms
Damage in one area, such as a few shingles or one flashing leak A targeted repair
Widespread wear, repeated leaks or a soft deck Plan a replacement

Leaks, missing shingles and worn flashing are covered by our roof repair services. When repairs no longer make sense, compare our roof replacement services. For water pooling on a low-slope roof, talk to our flat roofing contractors.

How do you prepare for a roof inspection?

Make it easy for the roofer to reach the roof and the attic, and share what you have noticed.

  • Clear access around the house and move cars from the driveway if the ladder needs that space.
  • Clear a path to the attic hatch.
  • Note where and when you have seen leaks or stains, and whether they appear only in heavy rain or during snow melt.
  • Have any past repair or replacement records ready.

If you are not sure what your roof needs, our roofing contractors can work through this roof inspection checklist with you.

Keep a leak log before the inspection

Water stains inside rarely sit right under the spot where water enters the roof, because water runs along the deck and rafters first. Before your roof inspection, write down where each stain is, when it appeared and the weather at the time. A note like “only in heavy rain from the west” or “only during snow melt” helps the roofer trace the leak much faster.

Need a roofer in the GTA?

Regular roof maintenance keeps small problems small, but some jobs need a professional. Maple Roofing and Masonry, a roofing and masonry contractor serving Toronto and the GTA, inspects and repairs roofs across Toronto, Mississauga, Brampton, Markham and Richmond Hill. Talk to our roofing contractors before winter.

Frequently asked questions

How often should a roof be inspected?

Check your roof from the ground at least twice a year, in the fall and spring, and after every major storm. Book a full roof inspection after storm damage, before buying or selling a home, or when the roof is near the end of its expected life.

How long does a roof inspection take?

It depends on the size and slope of the roof, how easy it is to reach, and whether the attic is accessible. Most of the time goes into checking the roof surface, flashing and attic.

Do roofers walk on the roof during an inspection?

Usually, where it is safe. On a steep, icy or fragile roof, the roofer checks it from a ladder at the eaves instead, so the inspection does not cause damage.

Can a roof be inspected in winter?

Yes, but snow can hide the roof surface. The attic, eavestroughs and any ice dams can still be checked in winter, and a full check of the shingles is best done once the snow has melted.

Is a roof inspection free?
Many roofing companies offer free inspections. Maple Roofing and Masonry offers free roof inspections across Toronto and surrounding areas.

Written by Polat Ayhan, Founder of Maple Roofing and Masonry.
Polat leads the company's roofing, masonry, foundation and basement waterproofing work for homeowners in Toronto, Mississauga, Brampton, Markham and Richmond Hill. View profile

GET A FREE ESTIMATE ☎ CALL NOW